Robot Coupe CMP 300 V.V. Spezifikationen PDF herunterladen (Seite 10)

ENGLISH

following the instructions normally specified on it’s

packaging container. Use a cloth lightly dampened

(not dripping) with the cleaning solution. Do not

allow liquid to come into contact with the electrical

components contained within the housing. Be careful

when cleaning around vents do not allow liquid to

drip or seep into the housing. Use a cloth lightly

dampened (not dripping) with water to remove

detergent/disinfectant then dry using a clean cloth.

After using the power mixer in a hot mixture, cool the

bottom of the tube in cold water before disassembling

the bell from the tube.

Clean immediately after use to prevent product from

sticking to surfaces.

• Tube and bell

There are two ways to proceed:

Simple cleaning procedure

Submerge the tube and bell in water and run for a

few seconds to clean. Unplug the power cord.

Complete cleaning procedure

Unplug the power mixer and rinse the bell under a

water tap. Remove the bell from the tube, then

remove the blade (wear cutting gloves) ! Be careful

to avoid damaging the surface of the blade shaft

and the watertight seals. Always dilute the deter-

gent/disinfectant (see above). Thoroughly dry all

parts before reassembling.

• Removing the whisk from the whisk holder

While griping the

ejector in one

hand and the holder

in the other, pull

the ejector in the op-

posite direction of

the arrow.

• Removing the ejector

Hold the whisk by the

wires in one hand.

With the other hand,

pull the ejector in

the direction of the ar-

row (see figure).

SPLASH GUARD

ASSEMBLY

- With a flat

screwdriver, uns-

crew the “ V “

screw from the

ring.

- Separate the A

and B arms from

the ring and put

it on the foot

C, keeping the

marking “ U.P “

on the side of the

motor.

Never immerse motor housing and/or handle

in liquid! The housing contains the electrical

components and is not sealed against liquid.

Contact with liquid can cause damage to the

blender and serious injury to the operator.

W ARNING

- Put the screw back

on the ring and tigh-

ten it.

Cover the ring with

the splash guard

protection sliding it

all along the foot C in

the arrow 1 direction,

the flange D must be

oriented down.

Be careful : align the

front sides of the two

parts.

- To remove the splash

guard protection for

cleaning follow these

instructions in the

reverse order.

CLEANING

• Motor housing

The power mixer must be clean through all stages

of production. Clean between each job using a deter-

gent or disinfectant. Dilute the detergent/disinfectant

• Always unplug the power mixer before

cleaning it!

• Always dilute bleach according to the

instructions on the label

• Never run the power mixer through a

dishwasher!

• Clean according to local health department

regulations.

W ARNING

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 46 47

Kommentare zu diesen Handbüchern

Keine Kommentare

Robot Coupe CMP 300 V.V. Spezifikationen Seite 10

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Mixer Robot Coupe CMP 300 V.V.